PAG 9707 PAGlink PL16 Charger (2 x V-Mount / iPC)
The 2-position PAGlink PL16 Charger is the ideal location charger for PAGlink V-Mount Li-Ion batteries. Up to 16 PAGlink batteries can be charged simultaneously (8 per channel).
PAGlink batteries communicate their state-of-charge to the charger and enable it to fully-charge all of the batteries, fast and efficiently, regardless of the differences between the batteries in terms of state-of-charge.
At the end of a shoot, simply link your batteries and connect them to the charger. The next day, they will be fully charged and ready to go.
The process is managed automatically by the PAGlink batteriesâ€™ high-speed serial network and PAGâ€™s Intelligent Parallel Charging software.
During charging, the percentage state-of-charge of each PAGlink battery is indicated on its individual display. The PL96T batteryâ€™s numeric display can be inverted, for legibility, with a single button press, and reverts automatically after removal.
The stages of the charging process for each channel are clearly indicated on the chargerâ€™s large backlit LCD screen. The most discharged batteries are given a higher charge priority. Fully charged batteries will stop accepting charge automatically.
PAGlink means no more power concerns when using high-current camera set-ups, and no more midnight battery swapping on the charger.
Designed specifically for parallel charging the following PAGlink batteries, from any state of charge, individually or linked: PAGlink PL96e Model 9303 PAGlink PL96T Model 9304
Suitable for parallel charging the following V-Mount Li-Ion batteries: PAG L95e/L96e Model 9310V PAG L96T Model 9305V Sony V-Mount Li-Ion
Suitable for sequentially charging the following V-Mount Li-Ion and Ni-MH batteries: PAG L95 Model 9360 PAG L110 Model 9302V PAG ZL-50 Model 9315V
Suitable for individually charging the following Ni-MH batteries: PAG ZL-150 Model 9316V PAG ZL-125 Model 9317V
Li-Ion Intelligent Parallel Charging program: maximum output 6A at 16.8V (100W approx.).
PAG ACS Ni-MH sequential charge program: output 3A.
No more than eight PAGlink batteries per channel may be charged. Batteries can be in any state-of-charge. The most-discharged batteries will be given a higher charge priority. Fully charged batteries stop accepting charge automatically and independently of other batteries.
This special program will automatically recover a Li-Ion battery where the output has been shut down. Additionally, the program detects batteries having a very low voltage, and initiates a special low charge current. The program will operate until the voltage has risen sufficiently for batteries to safely accept the normal charge current.
The internal microcomputer constantly monitors the battery under charge, as well as the operation of the charger’s own functions, which will be shut down to a safe condition should any of the tests fail.
90V to 265V AC. Frequency 50-60 Hz. Maximum consumption 140W.
Charger protected against short circuit and excess battery voltage.
Should mains failure occur during a charging program, or whilst the charger is connected, it will shut down to a safe condition.
The charge status of each PAGlink battery is indicated by its own display. The different stages of the charging process are indicated for each channel on the charger’s LCD screen. The charger is fully automatic in operation.
Designed to comply with electrical safety standard BS EN 60065 and UL6500. NOTE: U.K. mains leads are fitted with a 1" fuse to BS1362 rated 5A as standard.
Complies with the following EU Directives:
EMC Directive 89/336/EU.
Low Voltage Directive 73/23/EU.
Height: 75mm (3”).
Width: 210mm (8.3”).
Depth: 190mm (7.5”).
Weight: 1.4kg (3lbs).