PAG 9702VR (9702 VR 9702-VR 9702/VR) RMC4X-V Rack-Mountable Charger (4 x V-Mount / iPC)
Using a PAG charger to charge and manage your PAG batteries is the best way to achieve the maximum possible cycle life.
The RMC4X-V is a rack-mountable version of PAG's latest high-power, simultaneous Cube charger.
It can be used to simultaneously fast-charge Li-Ion batteries manufactured by PAG, Sony or IDX, via four V-Mount battery connectors.
The mounts connect to the charger via 4 x XLR4 connectors.
The charger is designed to be mounted in a half-width racking system, and measures 1U high.
Two units can be mounted side by side in a standard full-width 19-inch rack, by using connecting plates, available from PAG.
The RMC4X-V is ideal for use in outside broadcast vehicles, but it is equally suitable for use in a workshop environment.
A bespoke mounting-board for the connectors, that enables them to be fitted vertically inside the OB vehicle, can also be supplied.
The backlit LCD screen clearly indicates each stage of the charging process.
A Li-Ion battery recovery feature is included, to recover Li-Ion batteries if their cut-out has been tripped.
PAG V-Mount Lithium-Ion batteries.
Sony V-Mount Lithium-Ion batteries.
PAG V-Mount Nickel-Metal Hydride batteries.
Sony V-Mount Nickel-Metal Hydride batteries.
Nickel-Metal Hydride batteries are charged sequentially.
Li-Ion Intelligent Parallel Charging program.
Maximum output 6A at 16.8V (100W approx.).
This special program will automatically recover a Li-Ion battery where the output has been shut down. Additionally, the program detects batteries having a very low voltage, and initiates a special low charge current. The program will operate until the voltage has risen sufficiently for batteries to safely accept the normal charge current.
The internal microcomputer constantly monitors the battery under charge or process as well as the operation of the charger’s own functions which will be shut down to a safe condition should any of the tests fail.
90V to 265V AC. Frequency 50-60 Hz. EN6100-3-2 Power factor corrected. Maximum consumption 140W.
Charger protected against short circuit and excess battery voltage.
Should mains failure occur during a charging program, or whilst the charger is connected, it will shut down to a safe condition.
Comprehensive Liquid Crystal Display showing status of battery and charger. The charger is fully automatic in operation and no user controls are provided.
Designed to comply with electrical safety standard BS EN 60065 and UL6500. NOTE: U.K. mains leads are fitted with a 1" fuse to BS1362 rated 5A as standard.
Complies with the following EU Directives:
EMC Directive 89/336/EU.
Low Voltage Directive 73/23/EU.
0ºC to +40ºC (+32ºF to +104ºF).
Height: 44mm (1.7”)
Width: 210mm (8.3”)
Depth: 201mm (7.9”)
Weight (excluding charging connectors): 1.8kg (4lbs).
1 PAG L96 battery: 3hrs 15mins
2 PAG L96 batteries: 4hrs
3 PAG L96 batteries: 5hrs
4 PAG L96 batteries: 6hrs 30mins
These times are approximate only, and assume batteries are fully discharged. Charging times will be less if batteries are already partially charged.