DPA ST2011A, ST 2011 A, ST-2011-A , ST/2011/A Stereo Pair w. 2 x 2011A, Clips, Windscreens in Peli Case
Sell Your Gear
warranty on this product

DPA ST2011A, ST 2011 A, ST-2011-A , ST/2011/A Stereo Pair w. 2 x 2011A, Clips, Windscreens in Peli Case

code: ST2011A
  • £1,644.00
  • RRP: £1,800.00
Status   |   Usually dispatched within 24 hours
Loading...
Make An Offer
Ask a Question
Price Match
Add to Compare

DPA ST2011A (ST 2011 A,  ST-2011-A , ST/2011/A) Stereo Pair w. 2 x 2011A, Clips, Windscreens in Peli Case

FEATURES:

  • Sensitivity selected pair
  • Superb stage separation and level control
  • All-round workhorses
  • PeliTM Case transportation and protection

The ST2011A is a complete DPA 2011A Stereo Pair with two handpicked cardioid microphones, selected on sensitivity within ±1.5 dB making several stereo principles like XY and ORTF easy to obtain.

Finding its use on numerous stages and recording sessions, the ST2011A exhibits a previously unheard blend of clarity, richness and dynamic range, the 2011As perform close to much more exclusive microphone pairs.

The foam design in the heavy-duty transportation box allows for fast and easy exchange of microphone/accessory inlays.

Included in this kit:

  • Two carefully matched 2011A cardioid microphones, sturdy PeliTM case, holders, and windscreens.

 

Specifications for d:dicate™ ST2011A Stereo Pair with 2011A Cardioids

Directional pattern: Cardioid
Principle of operation: Pressure gradient, with interference tube
Cartridge type: Pre-polarized condenser, Twin Diaphragm Capsule
Frequency range: 20 Hz - 20 kHz
Frequency range, ± 2 dB, at 30 cm: 50 Hz - 17 kHz with 3 dB soft boost at 12 kHz
Sensitivity, nominal, ± 2 dB at 1 kHz: 10 mV/Pa; -40 dB re. 1 V/Pa
Equivalent noise level, A-weighted: Typ. 20 dB(A) re. 20 µPa (max. 23 dB(A))
Equivalent noise level, ITU-R BS.468-4: Typ. 33 dB (max. 36 dB)
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 74 dB(A)
Total Harmonic Distortion (THD) at 1 kHz: < 1 % up to 137 dB SPL peak
Dynamic range: Typ. 117 dB
Max. SPL, peak before clipping: 153 dB
Switchable attenuator: 0 dB / -20 dB
Output impedance: < 200 ohm
Minimum load impedance: 2 kohm
Cable drive capability: 100 m (328 ft)
Output balance principle: Impedance balancing with Active Drive
Common Mode Rejection Ratio (CMRR): > 60 dB
Power supply (for full specifications): 48 V Phantom power (± 4 V)
Current consumption: 2.8 mA
Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Color: Matte black
Weight: 164 g (5.8 oz)
Microphone diameter: 19 mm (0.75 in)
Microphone length: 198 mm (7.8 in)
Output voltage, RMS: > 5 V
Polarity: +V at pin 2 for positive sound pressure
Temperature range: -40 °C to 45 °C (-40 °F to 113 °F)
Relative Humidity (RH): Up to 90%
Sensitivity selection tolerance (at 1 kHz): ± 1.5 dB

 

Be the first to review ST2011A, ST 2011 A, ST-2011-A , ST/2011/A Stereo Pair w. 2 x 2011A, Clips, Windscreens in Peli Case. Write a review ›