Call: +44(0) 208 397 1407
Rated 4.75 / 5
Sell Your Gear Find Out More ›
Covid-19 Update Open as usual
Free Delivery On Orders Over £300 incl VAT

DPA ST4015C, ST4015, C ST4015-C, ST4015/C Stereo Pair w. 2 x 4015C, Clips, Windscreens in Peli Case

code: ST4015C
  • £2,419.00
  • RRP: £2,420.00
Availability | Usually dispatched within 24 hours

DPA ST4015C (ST4015, C ST4015-C, ST4015/C) Stereo Pair w. 2 x 4015C, Clips, Windscreens in Peli Case


  • Natural reproduction
  • Carefully matched within ±1 dB
  • Low profile – wide pickup area
  • PeliTM Case transportation and protection

Visually discreet, the 4015C Wide Cardioids represent an indispensably low-profile solution for audio engineers and set designers alike. Tremendously precise and natural sounding, the compact wide cardioids will excel when used on choirs, percussion setups, grand pianos, wind instruments, and much more. Also useful as spot mics for classical recording, the 4015C blends very naturally in with the main pair.

The DPA ST4015C is a complete DPA 4015C Stereo Pair with two carefully factory-matched wide cardioid microphones. Even though the standard tolerances on DPA Reference Standards are extremely low, a stereo match is even closer.

The specially selected DPA 4015C microphones are matched within ±1 dB on both frequency response and sensitivity.

The foam design in the heavy-duty transportation box allows for fast and easy exchange of microphone/accessory inlays.

Included in this kit:

  • Two carefully matched 4015C wide cardioid microphones, sturdy PeliTM case, holders, and windscreens.



Specifications for d:dicate™ ST4015C Stereo Pair with 4015C Compact Wide Cardioids

Directional pattern: Wide cardioid
Principle of operation: Pressure gradient
Cartridge type: Pre-polarized condenser
Frequency range: 20 Hz - 20 kHz
Frequency range, ± 2 dB, at 60 cm: 40 Hz - 20 kHz
Sensitivity, nominal, ± 2 dB at 1 kHz: 10 mV/Pa; -40 dB re. 1 V/Pa
Equivalent noise level, A-weighted: Typ. 18 dB(A) re. 20 µPa (max. 20 dB(A))
Equivalent noise level, ITU-R BS.468-4: Typ. 25 dB
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 76 dB(A)
Total Harmonic Distortion (THD): < 1 % up to 139 dB SPL peak
Dynamic range: Typ. 121 dB
Max. SPL, peak before clipping: 152 dB
Output impedance: < 200 ohm
Minimum load impedance: 2 kohm
Cable drive capability: 100 m (328 ft)
Output balance principle: Impedance balancing with Active Drive
Common Mode Rejection Ratio (CMRR): > 50 dB
Power supply (for full specifications): 48 V Phantom power (± 4 V)
Current consumption: 2.8 mA
Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Color: Matte black
Weight: 58 g (2 oz)
Microphone diameter: 19 mm (0.75 in)
Capsule diameter: 19 mm (0.75 in)
Microphone length: 64 mm (2.5 in)
Output voltage, RMS: > 4 V
Polarity: +V at pin 2 for positive sound pressure
Temperature range: -40 °C to 45 °C (-40 °F to 113 °F)
Relative Humidity (RH): Up to 90%
Matching tolerance: ± 1 dB
Phase deviation for kit: < 10°


Be the first to review DPA ST4015C, ST4015, C ST4015-C, ST4015/C Stereo Pair w. 2 x 4015C, Clips, Windscreens in Peli Case. Write a review ›