DPA Modular Active Cable, XLR, Side, 3 m (9.8 ft)

DPA MMP-ES (MMPES, MMP/ES, MMP ES, MMP.ES) Modular Active Cable, XLR, Side, 3 m (9.8 ft) 

The d:dicate MMP-ES Modular Active Side Cable by DPA Microphones is a microphone preamp. It is used with any d:dicate modular capsule for capturing audio in applications such as with hanging mics or low-profile table or instrument mics. The MMP-ES features a high quality preamp built with a 12mm housing and a 3-pin XLR connector. The capsule attaches to a cable with a length of 3 meters or optionally up to 30 meters. The preamp features impedance balancing with active drive to reject radio frequency interference. This model is built with a side mounted cable.

• The preamp is ultra transparent and features the DPA designed impedance balancing with active drive to reject radio frequency interference
• Can be combined with any DPA d:dicate modular capsule

• Output Connector XLR-3M, pin 1 shield, pin 2 signal + phase, pin 3 - phase
• Low-Cut Frequency -3 dB: 15 Hz
• Noise With Shorted Input, A-weighted: 0.6 µV
• Output Voltage RMS: 2.2 V 
• Peak: 3.1 V
• Type Of Electronic Circuit Active
• Total Harmonic Distortion (THD) At 1VRMS, 1kHz: < 0.2 %
• Dynamic Range 131 dB
• Output Impedance 100 Ω
• Cable Drive Capability 324' (100 m)
• Minimum Load Impedance 2 kΩ
• Common Mode Rejection Ratio > 40 dB
• Power Supply For Full Specifications: 48 V Phantom power (± 4 V)
• Current Consumption 3.5 mA
• Output Balance Principle Impedance balancing
• Temperature Range -40 to 113°F (-40 to 45°C)
• Relative Humidity Up to 90 %
• Dimensions (L x Diam) 118 x 0.75" (3000 x 19 mm)
• Weight 3.2 oz (91 g)

In the Box

• DPA Microphones d:dicate MMP-ES Modular Active Side Cable