DPA DM6000-BM (DM6000BM, DM6000/BM, DM6000_BM, DM6000.BM) Mic Base, Black, MicroDot
The Microphone Base comes with a built-in shock mount system that gives very good suppression of unwanted handling noise from a table or the like. Hidden mounting holes below the top cover make it possible to permanently affix the unit to a flat surface for an exclusive appearance. The audio cables are an integral part of the Microphone Base unit.
Connector 1 MicroDot Connector 2 MicroDot Length 65.6' (20 m) Cable Diameter 0.09" (2.2 mm)
Connector 1 MicroDot Connector 2 MicroDot Length 32.8' (10 m) Cable Diameter 0.09" (2.2 mm)
Analog Performance Operating Principle Pressure Gradient Transducer Condenser Polar Pattern Cardioid Frequency Range 20 Hz to 20 kHz Signal to Noise Ratio 74 dB A-Weighted Equivalent Noise Level 20 dB A-Weighted 33 dB ITU-R 468 Maximum SPL 144 dB SPL THD < 1% Impedance 100 Ohms Load Impedance 2 kOhms Sensitivity -40 dB CMRR 40...
Analog Performance Operating Principle Pressure Gradient Transducer Condenser Polar Pattern Cardioid Frequency Range 20 Hz to 20 kHz Signal to Noise Ratio 74 dB A-Weighted Equivalent Noise Level 20 dB A-Weighted 33 dB ITU-R 468 Maximum SPL 144 dB SPL THD < 1% Impedance 100 Ohms Load Impedance 2 kOhms Sensitivity -40 dB CMRR 40 dB...
Output Connector XLR-3M, pin 1 shield, pin 2 signal + phase, pin 3 - phase Low-Cut Frequency -3 dB: 15 Hz Noise With Shorted Input, A-weighted: 0.6 µV Output Voltage RMS: 2.2 V Peak: 3.1 V Type Of Electronic Circuit Active Total Harmonic Distortion (THD) At 1VRMS, 1kHz: < 0.2 % Dynamic Range 131 dB...
DPA MMP-GR (MMPGR, MMP/GR, MMP_GR, MMP.GR) Modular Active Cable, MicroDot, Rear, 1.8 m (5.9 ft)
The MMP-G Modular Active Cable is an ultra-transparent preamplifier. It can be combined with any modular capsule in the d:dicate™ Recording Microphones Series.
The MMP-G also features a MicroDot connector, which allows the microphone to be linked with all leading wireless miking solutions through the extensive range of DPA adapters.
The MMP-G is available in two variations, MMP-GR with the cable extending from the rear or MMP-GS with the cable extending from the side.
Output connector: MicroDot Low-cut frequency, -3 dB: < 10 Hz Noise with shorted input A-weighted: 1.0 µV Output voltage, RMS: 1.3 V Output voltage, peak: 1.8V Type of electronic circuit: Active THD @1VRMS, 1kHz: < 0.05 % Dynamic range: 122 dB Output impedance: < 10 Ohms Power supply (for full performance): 5V, 1 mA Color:...
Compatibility: d:fine headset microphone Sennheiser Wireless Systems Connector: Hardwired 3-pin LEMO Cable Length: 4.2' / 1.28m
Compatibility: d:fine headset microphone Shure Wireless Systems Connector: Hardwired TA4F Cable Length: 4.2' / 1.28m
Connector: Hardwired 3.5mm locking ring Compatibility: d:fine headset microphone Sennheiser Wireless Systems Cable Length: 4.2' / 1.28m
