DPA 4011ES Cardioid Microphone Side Cable

DPA 4011ES Cardioid Microphone Side Cable 

4011ES Cardioid Microphone, Side cable

• Ultra-compact spot or hanging mic

• Very linear frequency and phase response

• Huge dynamic range

• Low-key appearance

Ideal for unobtrusive spot miking, such as hanging or table use, the 4011E is an ultra-compact cardioid microphone from the modular DPA d:dicate Recording Microphones series.

With a length of only 3,5 cm, the low-key appearance of the 4011E is followed by the SM4000-C suspension mount, which is included in the package. This allows the 4011E to be hung from the ceiling and create precise and repeatable positions and angles when spot miking orchestra sections or ambience atmospheres.

Capable of handling high SPLs without distortion, the 4011E is perfectly tailored for close-miking applications, minimizing bleed from other instruments. Therefore chosen for close-miking of instruments like acoustic guitar, drums or grand piano, the 4011E with its accessories can be placed for instance in the piano frame.   

At any time and with no tools necessary it is possible to transform the basic 4011E microphone into a new configuration by combining it with another DPA microphone capsule or preamp.

Specifications for d:dicate™ 4011E Cardioid Microphone, Active Cable

Directional pattern: Cardioid

Principle of operation: Pressure gradient

Cartridge type: Pre-polarized condenser

Frequency range: 20 Hz - 20 kHz

Frequency range, ± 2 dB, at 30 cm: 40 Hz - 20 kHz

Sensitivity, nominal, ± 2 dB at 1 kHz: 10 mV/Pa; -40 dB re. 1 V/Pa

Equivalent noise level, A-weighted: Typ. 18 dB(A) re. 20 µPa (max. 20 dB(A))

Equivalent noise level, ITU-R BS.468-4: Typ. 25 dB

S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL): Typ. 76 dB(A)

Total Harmonic Distortion (THD): < 1 % up to 139 dB SPL peak

Dynamic range: Typ. 121 dB

Max. SPL, peak before clipping: 144 dB

Output impedance: 100 Ω

Minimum load impedance: 2 kΩ

Cable drive capability: 100 m (328 ft)

Output balance principle: Impedance balancing

Common Mode Rejection Ratio (CMRR): > 40 dB

Power supply (for full specifications): 48 V Phantom power (± 4 V)

Current consumption: 3.5 mA

Connector: XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase

Color: Matte black

Weight: 109 g (3.8 oz)

Microphone diameter: 19 mm (0.75 in)

Capsule diameter: 19 mm (0.75 in)

Microphone length: 35 mm (1.38 in)

Output voltage, RMS: 2.2 V

Polarity: +V at pin 2 for positive sound pressure

Temperature range: -40 °C to 45 °C (-40 °F to 113 °F)

Relative Humidity (RH): Up to 90%

Matching tolerance: ± 1 dB

Phase deviation for kit: < 10°