DPA ST2006A, ST2006, A ST2006-A, ST2006/A Stereo Pair w. 2 x 2006A, Clips, Windscreens in Peli Case

code: ST2006A

$2,023.76
Secure yours with a deposit of
RRP: $2,224.82
|
|

Status | Usually dispatched within 24 hours

Add to Compare

Description
Specification
Reviews
(0)

DPA ST2006A (ST2006, A ST2006-A, ST2006/A) Stereo Pair w. 2 x 2006A, Clips, Windscreens in Peli Case

FEATURES:

Sensitivity selected pair
Acoustic authenticity
Linear in a large frequency bandwidth
Peli^TM Case transportation and protection

The DPA ST2006A is a complete DPA 2006A Stereo Pair with two handpicked omni microphones, selected on sensitivity within ±1.5 dB.

As main AB stereo pair the 2006As deliver precise acoustic fingerprint and true tone. Orchestra, acoustic piano, guitar, wind instruments and choirs are among the most evident applications for this high-value-for-money pair.

The foam design in the heavy-duty transportation box allows for fast and easy exchange of microphone and accessory inlays.

Included in this kit:

Two carefully matched 2006A omni microphones, sturdy Peli^TM case, holders, and windscreens.

Specifications for d:dicate™ ST2006A Stereo Pair with 2006A Omnis

Directional pattern:	Omnidirectional
Principle of operation:	Pressure
Cartridge type:	Pre-polarized condenser, Twin Diaphragm Capsule
Frequency range:	20 Hz - 20 kHz
Frequency range, ± 2 dB:	50 Hz - 20 kHz with typ. 3 dB soft boost at 14 kHz
Sensitivity, nominal, ± 2 dB at 1 kHz:	40 mV/Pa; -28 dB re. 1 V/Pa
Equivalent noise level, A-weighted:	Typ. 16 dB(A) re. 20 µPa (max. 18 dB(A))
Equivalent noise level, ITU-R BS.468-4:	Typ. 28 dB (max. 30 dB)
S/N ratio (A-weighted), re. 1 kHz at 1 Pa (94 dB SPL):	Typ. 78 dB(A)
Total Harmonic Distortion (THD) at 1 kHz:	< 1 % up to 130 dB SPL peak
Dynamic range:	Typ. 114 dB
Max. SPL, peak before clipping:	141 dB
Switchable attenuator:	0 dB / -20 dB
Output impedance:	< 200 ohm
Minimum load impedance:	2 kohm
Cable drive capability:	100 m (328 ft)
Output balance principle:	Impedance balancing with Active Drive
Common Mode Rejection Ratio (CMRR):	> 60 dB
Power supply (for full specifications):	48 V Phantom power (± 4 V)
Current consumption:	2.8 mA
Connector:	XLR-3M. Pin 1: shield, Pin 2: signal + phase, Pin 3: - phase
Color:	Matte black
Weight:	160 g (5.6 oz)
Microphone diameter:	19 mm (0.75 in)
Length:	164 mm (6.5 in)
Output voltage, RMS:	> 5 V
Polarity:	+V at pin 2 for positive sound pressure
Temperature range:	-40 °C to 45 °C (-40 °F to 113 °F)
Relative Humidity (RH):	Up to 90%
Sensitivity selection tolerance (at 1 kHz):	± 1.5 dB

Be the first to review ST2006A, ST2006, A ST2006-A, ST2006/A Stereo Pair w. 2 x 2006A, Clips, Windscreens in Peli Case. Write a review ›